EN 10204 3.1 material certificates are one of the most common quality documents required on exported steel pipe. A 3.1 mill test certificate (MTC) records the actual inspection and test results for the delivered batch, linking the pipes to their heat number, chemistry, mechanical properties and applicable standard. For overseas buyers, the certificate is the paper trail that proves the supplied material matches the purchase order.
This guide explains what an EN 10204 3.1 certificate is, what it should contain, who can issue it, and the points buyers should verify before accepting a delivery.
Table of Contents
- What Is an EN 10204 3.1 Certificate?
- What the Certificate Covers
- 3.1 vs 3.2 Inspection Documents
- Who Can Issue a 3.1 Certificate
- Buyer Verification Checklist
- Frequently Asked Questions
What Is an EN 10204 3.1 Certificate?
EN 10204 defines inspection documents for metallic products. A 3.1 certificate is issued by the manufacturer’s inspection department, independent of the production unit, and states that the products delivered are in accordance with the order, accompanied by actual test results from tests carried out on the supplied batch or on material representative of it. It is a specific-test certificate, not a generic declaration of conformity.
What the Certificate Covers
A pipe 3.1 MTC commonly records: purchase order and pipe identification, material grade and standard, heat/batch number, dimensions (OD, wall, length), chemical composition by heat, mechanical test results such as tensile strength, yield strength and elongation, hardness where applicable, NDT results if specified, heat treatment condition, and the stamp/signature of the authorized inspector. The certificate number and heat traceability should match the markings on the pipes.
3.1 vs 3.2 Inspection Documents
A 3.1 document is issued by the manufacturer’s own authorized inspection body. A 3.2 document involves inspection carried out jointly by the manufacturer’s inspector and either the buyer’s inspector or an independent third-party inspector agreed in the order. 3.2 is requested on higher-risk, code-driven or audited projects, while 3.1 is the standard certificate for most export pipe deliveries.
Who Can Issue a 3.1 Certificate
The 3.1 certificate must be issued by a person or department within the manufacturer’s organization that is independent of the manufacturing unit, and authorized to release the material. The issuing company on the certificate should be the actual mill or manufacturer of the pipe; resellers cannot convert a supplier’s generic report into a valid 3.1 certificate without the independent inspection signature and traceable test records.
Buyer Verification Checklist
- The grade, standard and dimensions match the purchase order.
- Heat numbers on the certificate match the stencils or tags on the pipes.
- Chemistry and mechanical values fall within the specified standard limits.
- Any required NDT, hydrostatic or hardness tests are listed with results.
- The certificate carries a valid signature, title and company stamp.
- The document language and format meet the buyer’s customs and audit requirements.
Frequently Asked Questions
Is a 3.1 certificate the same as a material declaration?
No. A simple declaration of conformity states that the product meets the order, while a 3.1 certificate provides actual test results and heat traceability. The 3.1 document is the stronger evidence for inspection and audit.
Can a 3.1 certificate be issued after delivery?
Certificates are normally prepared from the production and test records of the delivered batch. If records are lost, re-testing or a third-party inspection may be required; buyers should request the correct certificate type at order stage rather than after delivery.
Conclusion
An EN 10204 3.1 MTC gives overseas buyers traceable proof that exported steel pipe meets the ordered grade, dimensions and test requirements. When you send your enquiry to Shiwang Pipe, state the certificate type and standard required, and we will confirm whether 3.1 or a third-party 3.2 inspection document fits your project.

